Biamp RED-1 - Manual (Page 11)

11
RED-1 INstAllAtION
When installing the RED-1F using the retro-fit plate or the back-box, fasten the trim ring using the four screws provided to either the retro-
fit plate or the back-box. Once the trim ring has been fastened to the retro-fit plate or the back-box, guide the RED-1F front plate at an
angle into the top of the trim ring to seat the tabs on the top of the front plate. Once this has been done rotate the bottom of the front plate
towards the bottom of the trim ring until it is seated in the trim ring via the bottom clip.
If the front plate needs to be removed use a screw driver or other suitable tool to engage the latch at the bottom of the RED-1F to detach
from the trim ring.
Refer to page 12 for instructions regarding the use of the insulation displacement connector.
Exploded view showing pieces required for mounting to the retro-fit plate
or the Raco™ 254 back-box
Front Plate
Retro-Fit Plate
Raco™ 254
Trim Ring