Biamp RED-1 - Manual (Page 6)

6
RED-1 sEt Up
Device Setup Mode
The RED-1 can be configured without connecting to a functional Audia or Nexia network. To enter setup mode, connect the RED-1 to a
PoE source and place the jumper or any metal object across the locksmith pins. When configuration is complete, remove the jumper and
attach it to only one pin to resume normal operation. Please note: many of the configuration settings can be accessed via the Audia or
Nexia software.
The cursor has two modes: select and modify. In select mode, the cursor appears as a gray box. When scrolling through the available
items in the list, the gray box will highlight the current selection.
On fields that can be modified, use the Select button to transition to and from modify mode. In modify mode, the cursor appears as an
outline box. Use the scroll wheel to adjust the setting up or down.
Some screens have additional buttons that are used to accept (OK), reset, or cancel changed settings. Use the scroll wheel to navigate
the cursor to these buttons and press the Select button. The OK button saves the setting and exits the screen. The Reset button clears
the setting and does not save it. The Cancel button exits the screen without saving the setting.
Locksmith: Bridge jumper
pins to enter setup mode
“Select” mode in device
setup menu
“Modify” mode in device
setup menu