Biamp RED-1 User Manual
Page 12
12
RED-1 INstAllAtION
Connect the wire according to the color code silkscreened as text next to the IDC or as shown on the label on the back enclosure
(see figure below). The color code uses the T568A standard for wiring. When using the T568B wiring scheme, please note that the orange
wire pair (OR and WH/OR) and green wire pair (GR and WH/GR) need to be swapped. After inserting the wires, press the tabs until the
insulation is punctured with an audible click. No wire stripping is necessary.
Figure X: IDC wiring scheme
Note the appropriate bend radius requirements for category cables as shown in the figure below.
Software support in Audia configuration software Version 5.1 and Nexia Version 3.1 or later provides user programming of all remote
functions, network setup, device naming, and device maintenance.
Visit www.biamp.com/support.php to obtain firmware and software updates related to this product. To speak with a Product Applications
Engineer, please call 1-800-826-1457 or email [email protected].
585.0268.90B
Insulation Displacement Connector (IDC)