Operation and function, Safety instructions, Operation of the lfc / lfm – Burkert Type 8709 User Manual
Page 34: Operation and function 8, Safety instructions 8.1, Operation of the lfc / lfm 8.2
34
Operation and function
OperaTiOn and funcTiOn
8.
safety instructions
8.1.
Warning!
risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the device and the area around it.
The operating personnel must know and have understood the contents of the operating instructions.
•
Observe the safety instructions and intended use.
•
Only adequately trained personnel may operate the equipment/the device.
•
Operation of the lfc / lfM
8.2.
The LFC / LFM is operated by means of analogue standard signals or field bus communication as well as binary
inputs. For operating and status displays 3 or 4 LEDs are also used as binary outputs.
There is also a serial interface (RS232) via which a connection to a PC can be established, e.g. using the “Mass
Flow Communicator” software.
selecting the standard signals / assigning the binary inputs
•
The required configuration of the standard signal type as well as the assignment of the binary inputs can
be specified on order placement or can be configured via the “Mass Flow Communicator” software (see
also Chapter
10.1.3. Mass Flow Communicator (PC software)).
led assignment / assigning binary outputs
•
The LED assignment (except the Power and the Error LED) as well as the assignment of the binary outputs
can also be configured via the “Mass Flow Communicator” PC software (see also Chapter
Flow Communicator (PC software)).
english
Type 8718, 8719 / 8708, 8709