Burkert Type 8035 - Manual (Page 6)

2. inTenDeD use
use of the device that does not comply with the instructions
could present risks to people, nearby installations and the
environment.
• The flowmeter-totalizer 8025 or 8035 is intended to measure
the flow rate and totalize the volume of liquid.
• This device must be protected against electromagnetic interfe-
rence, ultraviolet rays and, when installed outdoors, the effects
of climatic conditions.
• This device must be used in compliance with the characteristics
and commissioning and use conditions specified in the contrac-
tual documents and in the user manual.
• Requirements for the safe and proper operation of the device
are proper transport, storage and installation, as well as careful
operation and maintenance.
• Only use the device as intended.
→
Observe any existing restraints when the device is exported.
3. bAsic sAfeTy informATion
This safety information does not take into account:
• any contingencies or occurences that may arise during installation,
use and maintenance of the devices.
• the local safety regulations for which the operating company
is responsible including the staff in charge of installation and
maintenance.
danger due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
danger due to electrical voltage.
• Put the power switch to OFF before carrying out work on the
device.
• Shut down and isolate the electrical power source before car-
rying out work on the system.
• Observe all applicable accident protection and safety regulations for
electrical equipment.
danger due to high temperatures of the fluid.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before loosening
the process connections.
danger due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and safety
relating to the use of aggressive fluids.
4
Intendeduse
Type 8025/8035 battery powered
English