Fluid Components International CMF Series Guide - Manual (Page 8)

FLUID COMPONENTS, INTL
FlexCOR TM Model CMF Series Coriolis Flow Meter 8 Doc. No. 06EN003318 Rev. B
Password
The lowest line is the subtitle line (ST) which either will add information to the title line or keep individual information independent
of the title line.
F: The alarm field. Two flashing triangles will appear by a fault condition.
M: The mode field. The symbols indicate the following.
Communication mode Product identity Output Reset mode
Service mode Language mode External input
Operator menu Basic settings Sensor characteristic
Ready for change Access to submenu
Value locked RESET MODE: Zero setting of totalizers and initialization of setting
L: The lock field. Indicates the function of the lock key.
Menu Modes
The menu is built up in two parts. An operator menu and a setup menu.
Operator menu
The operator menu is for daily operation. The operator menu is customized in the operator menu setup. The transmitter always
starts in the operator menu no. 1. The page forward and page backward keys are used to step through the operator menus.
Setup menu
The setup menu is for commissioning and service only.
Access to the setup menu is gained by pressing the top up key for 2 seconds. The setup menu will operate in two modes:
View mode Setup mode
View mode is a read only mode. The pre-selected settings can only be scanned.
Setup mode is a read and write mode. The pre-selected settings can be scanned and changed. Access to the setup mode is
protected with a password. The factory set password is 1000.
Access to a submenu in the set up menu is gained by the lock key. A short press on the top up key will go back to the previous
menu. A long press (2 sec.) on the top up key will exit the setup menu and bring to operator menu no. 1.
The SETUP MENU can be operated in two different modes: VIEW MODE (Read only) and CHANGE MODE (Read and write
mode)
To access to view mode, press the forward key when in the password menu.