Clear-Com RCS-2700 - Manual (Page 29)

R C S - 2 7 0 0 S O U R C E A S S I G N M E N T P A N E L 2 - 9
need a PC with the RCS-WIN program installed. For detailed instructions, see
the RCS-WIN Instruction Manual.
The second function of the Code-Reset button is to return a main or expansion
unit to its factory default settings. If there are presets defined and set, or source
and destination names entered, they will all be erased when this function is used.
This function must therefore only be performed with careful consideration. This
function only affects the main or expansion unit it is performed upon; it does not
affect an entire system. Setting a unit back to its factory default settings will also
set the unlock code for that unit back to the “no-lock” code of 0.
Warning:The following steps will completely erase all programmed settings and
return the main or expansion unit to the factory default settings.
To return an RCS-2700 unit to the factory default settings:
1. Turn power to the unit off.
2. Press and hold the Code-Reset button.
3. Turn power to the unit on while continuing to hold the Code-Reset button.
4. Release the Code-Reset button when the front-panel display reads “CC.”
5. If the Locked light remains on, turn power to the unit off and then on again.
After a few seconds, the start-up sequence will begin and the factory default
settings will be restored.
CONNECTING A REMOTE RCU-67 (3)
For additional programming capability, you can connect an RCU-67 Remote
Control Unit to the rear-panel jack provided for it. The RCS-2700 will recognize
the RCU-67 and begin communicating with it a few seconds after it is
connected.
Only one RCU-67 Remote Control Unit can operate at any one time. If at any
one time two RCU-67s are connected, only the front-panel RCU-67 will
operate. The RCU-67 connected to the front-panel jack always takes precedence
over the RCU-67 connected to the rear-panel jack.
Warning:Do not connect a PC to the PC serial port while an RCU-67 Remote
Control Unit is plugged into the jack on the rear panel. Doing this will
connect multiple serial ports which are not designed to be connected.
Either one or both of the ports will not work.
CONNECTING A PC (4)
For ultimate programming capability, you can connect a PC to the PC serial port
on the back of the main RCS-2700 unit. You can then program the RCS-2700
directly from the PC. The PC must have the RCS-WIN program installed.
Communication with the PC will be suspended if an RCU-67 Remote Control
Unit is plugged into the front-panel jack.
Warning:Do not connect an RCU-67 Remote Control Unit to the rear-panel jack
while a PC is connected to the serial port. Doing this will connect
Warning: Do not connect a
PC and an RCU-67
Remote Control Unit to
the RCS-2700 unit at the
same time.