Clear-Com RCS-2700 - Manual (Page 42)

R C S - 2 7 0 0 S O U R C E A S S I G N M E N T P A N E L 2 - 2 2
WIRING SUMMARY FOR 15-SOURCE SYSTEMS
The following table shows the basic groups of connections that form various
sized 15-source systems. Check that the wiring indicated for each topic has been
performed. Refer to wiring diagrams elsewhere in this chapter for the detailed
connections.
Table 2-5: Wiring Configurations for a 15-Source System
* Exceptions are unconnected source channels, which should be set to “on.”
* *If you want to monitor power with RCS-WIN or with an RCU-67 Remote
Control Unit, you must jumper pin 3 to pin 2, and jumper pin 6 to pin 5.
BASIC WIRING FOR 24-DESTINATION, 15-SOURCE
SYSTEM
ADDITIONAL WIRING FOR 48
DESTINATIONS
ADDITIONAL WIRING FOR 72
DESTINATIONS
MAIN UNIT UNIT 1 UNIT 2 UNIT 3 UNIT 4 UNIT 5
ADDRESS M 1 2 3 4 5
SOURCES 1–7 8–15 1–7 8–15 1–7 8–15
DESTINATIONS 1–24 Source
expansions
from main
unit 25–48 Source
expansions
from unit 2 49–72 Source
expansions
from unit 4
TERMINATION
SWITCHES
On On Off* Off* Off* Off*
SOURCE
EXPANSIONS
To unit 1
destinations Tied together To unit 3
destinations
Tied together To unit 5
destinations
Tied together
DESTINATION
POWER (SINGLE
CHANNEL)
+30 VDC No
connection +30 VDC No
connection +30 VDC No
connection
DESTINATION
POWER
(2-CHANNEL TW)
No
connection** No
connection** No
connection** No
connection** No
connection** No
connection**
RCS POWER +30 VDC +30 VDC +30 VDC +30 VDC +30 VDC +30 VDC
DATA LINK To unit 1 To unit 2 To unit 3 To unit 4 To unit 5 Last
connection