8 connecting to a lan (local area network), 6 connecting to an external pc running ehx, Connecting to a lan (local area network) – Clear-Com HX System Frames User Manual
Page 44: Connecting to an external pc running ehx
4.5.8 Connecting to a LAN (Local Area Network)
The LAN connector on the Eclipse HX-PiCo has standard Ethernet pin assignments:
Figure 15: Standard pin assignments for a LAN connector
Important note:
If the LAN connector is used a ferrite core must be added to the socket end of each cable. A
suitable ferrite is Würth Electronik part: 74271132. A shielded CAT-5 cable should be used.
4.6 Connecting to an external PC running EHX
The computer is normally connected to the matrix using the LAN connector (a standard RJ-45
Ethernet connector) on the rear of the HX-PiCo.
Ethernet connection allows single or multiple PCs to control, configure, monitor, and diagnose
single or multiple matrices from anywhere on the WAN / LAN.
Note:
A ferrite core must be added to the socket end of each Ethernet cable to comply with European
EMC standards. A suitable ferrite core is Würth Electronik part: 74271132. Shielded CAT-5
cable is recommended for Electro Magnetic Compliance in EC countries.
44
Eclipse HX-PiCo User Guide