Clear-Com Eclipse-Omega - Manual (Page 254)

Clear-Com
Eclipse Configuration Software Instruction Manual
7 - 2
The top area also provides access to key Label Options and Local
Assignments.
Keys may be configured with a number of talk and listen properties:
The talk and listen properties that may be assigned to a key are:
• TALK sets a talk from the panel to a destination with no automatic
listen to the destination.
• LISTEN sets a key to listen to the source without talking to the
destination at the same time.
• TALK & LISTEN sets a talk key with listen.
• TALK & FORCED LISTEN sets a talk key with permanently made
listen.
• DUAL TALK & LISTEN sets a dual talk and listen key (only on
pushbutton panel types). This make the pushbutton activate a
TALK on a press and hold and LISTEN with a short press on the
same pushbutton.
Note: On i-Stations and ICS-2003 panels, when a port is set as a
Global IFB it will appear twice in assignment picklists, with
one entry being the original port, and one being the IFB.
Controls will appear three times - once for talk, once for
listen, and once for talk and listen
The following sections describe in detail how to program various types
of panel. The basic method is the same for all panels so the
procedures shown can be applied to similar types of panels where they
are not specifically covered.
The main panel types covered indicate the various panel specific
differences in the programming of these panel types.