Clear-Com FreeSpeak - Manual (Page 43)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 43 of 49
3 Remove the front cover
by pulling it forward.
Apply
pressure
towards the table on
the top (encoder part)
of the chassis to keep
the PCBs from lifting
as you remove the
front
bodywork
Remove the 2 screws
holding the PCB by the
XLR connector
4 Separate the front and
rear parts of the
beltpack enough for
the connectors to clear
by lifting the boards
vertically. Be aware
that there are 3 boards
loosely
connected
together. If possible lift
all 3 without separating
them.
Once you have cleared
the connectors, open
the unit like a clamshell
around the wiring as
not
to stress the
cables, and rest on a
work surface The XLR
may rest loose