Clear-Com FreeSpeak - Manual (Page 7)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 7 of 49
2.2.1 “Freespeak Upgrader” for Beltpack Updates
1) Run “FreeSpeak Upgrader” on the PC (make sure that the correct COM port is
selected).
2) Make sure the selected Firmware File is the latest Beltpack release (e.g.
xxxxx.mot) and is of the correct type (ie MKI KIRK or MKII KIRK). The flow
diagram will help you to determine your hardware version. See the release notes
for the latest version information.
3) Switch off the Beltpack.
4) Connect the Beltpack to the PC via the registration cable
5) Click Download.
6) Press the power button on the beltpack to begin the download. The “FreeSpeak
Upgrader” progress bar will start progressing.
7) The “FreeSpeak Upgrader” status bar will indicate when the download has
completed or failed. If the download failed, remove and reinsert the batteries,
check the cables and try downloading again skip to step 5.
8) Once the firmware file has downloaded successfully (takes about 2.5 mins)
9) Remove the registration cable and power off the Beltpack.
10) If the unit is dissembled (remove at least one battery) fit the unit back together
and replace the screws.
11) Replace the batteries and power up the unit and check for the correct version and
operation.