Clear-Com FreeSpeak User Manual
Page 49
CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05
VGC Part No.- 810372Z-MAN-6
Page 49 of 49
Open
the
unit
like
a
clamshell.
Separate the case by lifting
the back up, while attempting
to keep the front of the unit
and PCB together
Take care when moving two
halves apart as the cables to
the battery are often tight
Adjust the dip switches as
required
Close the unit and replace
the battery without the screws
Power up and run the DECT
loader to upgrade the DECT
NOTE: For dip switch settings
See Preparing FS-BP MK I &
PD2202 Beltpacks Only.
Remove a battery and set the
dipswitches
back
to
the
default.
When reassembling the unit,
take care as to not crush the
battery cables with the case.
Use a small screwdriver (or
similar) to try to keep the
cables clear of the case until
it is sealed.
Screw up the unit