Clear-Com Concert for Newsroom - Manual (Page 19)

19 Server Installation Guide
3.1.4 Retrieving the IP address of the Concert Server
The IP address of the Concert Server is required for:

Concert Client applications.

The web-based CMI.
Note:
To prevent configuration complications, only connect the eth0 Ethernet port to your network switch. This is
usually the left-most Ethernet port when viewing the server from the rear.
The IP address of the server should be displayed just above the login prompt. If not, this usually means that
either an address was not retrieved from your DHCP server or the server is not connected to your network.
See 3.1.1 for more information.
Another way to check the IP address is as follows:
1. At the prompt, type the following command:
service concert showip
The resulting output provides the following information for each active Ethernet interface detected:

The configured IP address

The detection of a physical connection to a switch.