INSTEON SwitchLinc Dimmer (Dual-Band) - (2477D) Manual (Version 7.0 and Newer) - Manual (Page 11)

Page 11 of 16 Rev: 3/29/2013 10:32 AM
1) Turn SwitchLinc off
2) Tap Set button
SwitchLinc will beep
3) Test:
a. Brighten SwitchLinc to a random brightness level (e.g. 75%)
b. Turn SwitchLinc off
c. Turn SwitchLinc back on
Light will turn on at the defined brightness level
Local Ramp Rate
Default = ½ second. The local ramp rate is the time it takes for SwitchLinc to reach 100% brightness
(from off) when controlled at the paddle. It is adjustable from instant to 8 minutes (with software) and
instant to 5 seconds (using Set button).
1) Adjust SwitchLinc brightness corresponding to the desired local ramp rate in the table below
Hint: dim momentarily from 100% for 0.5 seconds or brighten momentarily from off for 2.0 seconds
Brightness Ramp Rate
100% Instant
51-99% ½ second
01-50% 2 seconds
Off 5 seconds
2) Double-tap Set button
SwitchLinc will beep
3) Test by turning off and then back on via the local switch
Light will ramp off and back on at the new local ramp rate
Note: if SwitchLinc recognized two single taps it will have adjusted the local on-level instead of
the local ramp rate. Return to step 1 and try again
Change LED Brightness (or turn it off)
Default = 50% bright.
1) Press and hold Set button until it beeps
LED will start blinking green
2) Press and hold Set button until it beeps
LED will start blinking red
3) Press and hold Set button until it beeps
LED will stop blinking
4) Use SwitchLinc on and/or off buttons to brighten or dim LEDs to desired level
5) Tap Set button
SwitchLinc will double beep and return to ready mode
Beep on Button Press
Default = off. This setting is adjustable via software or a central controller only.