INSTEON SwitchLinc Dimmer (Dual-Band) - (2477D) Manual (Version 7.0 and Newer) - Manual (Page 13)

Page 13 of 16 Rev: 3/29/2013 10:32 AM
X10
X10 address 1 optional (comes unassigned)
X10 transmitter Yes
X10 receiver Yes
X10 status response Supported
X10 resume dim Supported (by setting local on-level to zero)
X10 minimum transmit level 3.2 Vpp into 5 Ohms
X10 minimum receive level 20mV into 5 Ohms
Mechanical
Mounting
Standard North American single or multi-gang electrical boxes
Wires
Line (black) – 16 gauge
Load (red) – 16 gauge
Neutral (white) – 16 gauge
Ground (bare copper) – 16 gauge
Back case color Clear
Switch paddle and frame color White, almond, light almond, ivory, gray, black or brown
Set button 1
Plastic UV stabilized polycarbonate
Beeper Yes
Beep on button press Optional (off by default)
Status LEDs 1 dual-color red/green and 9 white
Dimensions 4.1” x 1.8” x 1.2” (104.1mm x 45.7mm x 30.5mm)
Depth into electrical box 0.99” (25mm)
Weight 3.6 oz. (102 grams)
Operating environment Indoors
Operating temperature range 32 ° to 104 ° F (0 ° to 40 ° C)
Operating humidity range 0-90% relative humidity, non-condensing
Storage temperature range -4 ° to 158 ° F (-20 ° to 70 ° C)
Electrical
Voltage 100-277VAC (+/- 10%) (Rev. 7.0 models and later, earlier models are 120v
Neutral connection required Yes
Frequency 50/60Hz, auto detected at power-up
Load type(s) Incandescent
Maximum dimmer load 600 watts
Surge resistance Up to 500VAC
User replaceable fuse No
Hardwired remote control No
Retains all settings without power Yes, saved in non-volatile EEPROM
Standby power consumption <1 watts
Certifications FCC, IC Canada
FCC ID SBP2477D and 5202A-2477D
Safety approval(s) ETL (Intertek Testing Services) to UL/ANSI standard 1472