INSTEON Thermostat with Humidity (2441TH) Manual - Manual (Page 10)

Page 10 of 28 Rev: 1/21/2014 8:35 AM
Fan and Hold Button Operations
Fan button operations
• The Fan button cycles between Auto and Always On.
• On the display, it simply indicates the text “Fan Always” when selected. There is no indication for Fan
Auto.
Hold button operations
• The Hold button overrides a preprogrammed mode until Hold is turned off.
NOTE:
• While Hold is enabled, the next preprogrammed time that comes in Time of Day Mode will be ignored.
• While Hold is enabled, the preprogrammed time notations are not shown (i.e. Wake, Leave, Return
and Sleep).
• Hold can be remotely enabled/disabled from an INSTEON controller.
Master Button Operation
First press and hold:
Makes the local INSTEON Thermostat the master temperature controller
• To perform this, press and hold Master button for 3 seconds.
INSTEON Thermostat beeps once.
• Release.
Note: This is only valid if at least one INSTEON Thermostat Zone Thermostat is linked to INSTEON
Thermostat.
Before pressing Master button:
• Notice that the left remote sensor is currently
the Master temperature controller.
After pressing and holding Master button:
• Notice that the left remote sensor is no
longer the Master temperature controller.
• The local INSTEON Thermostat is now the
Master controlling temperature.
Note: If no INSTEON scene is programmed to a INSTEON Wireless Thermostat, pressing and holding for
3 seconds will cause the Master segment to display while the button is being held.
Always On Auto
Hold On Hold Off