INSTEON Thermostat with Humidity (2441TH) Manual - Manual (Page 8)

Page 8 of 28 Rev: 1/21/2014 8:35 AM
Third press of Time/Sensor:
Day settings
• Up/Down arrows cycle through each day of the week as shown.
Fourth press of Time/Sensor:
Clock Format setting (12- or 24-Hour clock)
• Entire “time” blinks.
• Up/Down arrows cycle between 12- and 24-hour clock format.
Note: AM/PM is not displayed when in 24-Hour format.
Press Time/Sensor a fifth time to exit.
Program Button Operation
• The Program button allows you to set up the various preprogrammed modes (Wake, Leave, Return
and Sleep).
• Go to the next step by pressing Program again.
• Exit Program setup by:
- Timing out (4 minutes)
- Pressing Mode button
Note: Colored text below indicate element that should be blinking during setting procedure.
First press of Program:
Selects from available pre-program modes
Up/Down arrows cycle through Wake, Leave, Return and Sleep.
NOTE:
• Energy is not a part of this option.
• Once a preprogrammed mode is selected, that item remains displayed throughout to
indicate the mode you are programming.
• The current mode settings are displayed on the thermostat at each setup step.
Second press of Program:
Day setting
• Up/Down buttons cycle among all week, weekdays, weekend days and each day, as shown.