INSTEON Thermostat with Humidity (2441TH) Manual - Manual (Page 4)

Page 4 of 28 Rev: 1/21/2014 8:35 AM
INSTEON Thermostat Sample
The gray buttons
are under the
INSTEON
Thermostat door
Cool setpoint
Heat setpoint
Time of day
state
Humidity level
Time
Current
temperature
Temperature of remote
sensors or zone thermostats
position 1 and position 2
(up to 2)
Current
thermostat
mode:
Off, Auto,
Heat or Cool
INSTEON Thermostat Button Overview
1) Up/Down buttons adjust the temperature setpoint based on the current mode.
2) Mode allows the user to select the current operational mode of the HVAC system. It cycles
among Off, Heat, Cool, Auto and Time of Day.
3) Energy (Leaf) button is designed as a quick access option that saves energy (and money). When
pressed, it will set back the setpoint by a specified value. The default value is 4° from the current
setting. To change the default offset value you must use software such as HouseLinc
TM .
4) Hold overrides a preprogrammed mode to stay in the current settings mode.
5) Fan cycles between Auto and Always On – there is no indicator for Auto Fan.
6) Master makes this device the master temperature controller when you have one or more zone
thermostats. Pressing and holding “Master” does not alter any scene or screen settings; it just
defines this INSTEON Thermostat as the master temperature controller.
7) Time/Sensor allows you to set the day and time. It cycles among hour, minute, day and time
programming.
8) Program allows you to set up the various preprogrammed modes (Wake, Leave, Return and
Sleep). It also allows you to setup various features and calibrate the temperature and humidity.
9) Set is for adding and removing INSTEON Thermostat to and from INSTEON scenes. It functions
like the Set button on other INSTEON devices.
2
1
4 5 6 7 8 9 3