INSTEON Thermostat with Humidity (2441TH) Manual - Manual (Page 23)

Page 23 of 28 Rev: 1/21/2014 8:35 AM
• Temperature offset
• Humidity offset
Factory Reset
1) Press and hold INSTEON Thermostat’s Set button until it beeps.
INSTEON Thermostat will beep.
INSTEON Thermostat Set LED will blink
green .
2) Press and hold INSTEON Thermostat’s Set button again until it beeps.
INSTEON Thermostat will beep.
INSTEON Thermostat Set LED will blink
red .
3) Double-tap Set button.
4) Press and hold Set button again for about 10 seconds.
INSTEON Thermostat will emit a long beep and its display will blink all segments.
5) When blinking/buzzing stops, release Set button and wait 10 seconds.
INSTEON Thermostat will perform a series of self tests, then return to normal operations.
INSTEON Thermostat display will return to normal.
Specifications
General
Product name INSTEON Thermostat
Brand/manufacturer INSTEON
Manufacturer product number
2441TH US
2732-422 EU
2732-522 AUS/NZ
UPC
813922-010824 US/Can
813922-012859 EU
813922-012866 AUS/NZ
Warranty 2 years, limited
INSTEON
INSTEON powerline mesh repeater No
INSTEON RF mesh repeater Yes
INSTEON controller Yes
INSTEON responder Yes
Maximum links/scenes 400
LED
Red when Heating is active, green when Cooling is active
Off when neither mode is active
Blinks
red or green during setup
LED brightness LED can be enabled or disabled locally or via software
Local control Yes
Commands supported as controller On Off
Commands supported as responder
On Off
Beep