INSTEON Smoke Bridge (2982-222) Manual - Manual (Page 6)

Page 6 of 14 2982-222 - Rev: 1/21/2014 8:34 AM
~15 seconds after it sends the All Clear command, it will turn solid green
Responder will respond appropriately
Make Smoke Bridge a Controller of Multiple Responders
1) Press and hold Smoke Bridge set button until it beeps
LED will start blinking green
2) Tap Smoke Bridge set button
LED will start double-blinking green
3) For each responder you are adding:
- Adjust responder to desired scene state
- Press and hold Set button until it double-beeps
4) Tap Smoke Bridge set button
Smoke Bridge will beep and LED will stop blinking
5) To test, first change the responder to a different state then the desired state
6) Test by tapping Smoke Bridge set button
The Set button will cycle through the following notifications with a brief delay between each
- Smoke detected
- Carbon Monoxide (CO) detected
- Low Battery detected
- Error
- All Clear
Smoke Bridge LED will blink red during these steps
~15 seconds after it sends the All Clear command, it will turn solid green
Responder will respond appropriately
Remove Smoke Bridge as a Controller
If you no longer want Smoke Bridge to control another device (or are removing Smoke Bridge from your
network) it is important that you follow the instructions below for each responder.
1) Press and hold Smoke Bridge set button until it beeps
LED will start blinking green
2) Press and hold Smoke Bridge set button until it beeps again
LED will start blinking red
3) Press and hold responder set button until it double-beeps
Smoke Bridge will double-beep and LED will stop blinking
4) To test, first change the responder to a different state then the desired state
5) Test by tapping Smoke Bridge set button
The Set button will cycle through the following notifications with a brief delay between each
- Smoke detected
- Carbon Monoxide (CO) detected
- Low Battery detected
- Error
- All Clear
Smoke Bridge LED will blink red during these steps
~15 seconds after it sends the All Clear command, it will turn solid green
Responder will not respond