INSTEON Smoke Bridge (2982-222) Manual - Manual (Page 8)

Page 8 of 14 2982-222 - Rev: 1/21/2014 8:34 AM
Local Control Operation and Testing
Tap Set Button Once Cycles
through following:
Responders LED
Smoke detected
Carbon Monoxide (CO) Detected
Low Battery Detected
Error
All Clear
Responders for each group will
be activated as it cycles
through the various notifications
Blinking Red until ~10
seconds after All Clear, then
Solid Green
Notes:
If you link to other INSTEON devices using the Set button, only the “Smoke Detected” signal will trigger
the INSTEON devices. To verify Smoke Bridge puts the responders in the correct state, you must put the
responders into a different state and then use Set button to test.
If you are using software, such as HouseLinc to manage Smoke Bridge, you can create scenes for any of
the above groups.
The Smoke Detector Test group is only initiated by pressing and holding the Test button on the First Alert
smoke alarm.