Comprehensive CVG-724xl - Manual (Page 14)

10
6 Connecting your Presentation Switcher / Scaler
To connect the CVG-724xl as illustrated in the example 1 in Figure 7, do the
following 2 :
1. Connect the following video sources 3 :
One 4 composite video source (for example, a composite video player) to
the AV1 RCA connector
One 4 s-Video source (for example, an s-Video player) to the YC1 4p
connector
A component video 5 source (for example, a Betacam video player) to the
three RCA connectors, Y, Pb/Cb, and Pr/Cr 6
One computer graphics source 7 to the VGA 1 HD15 connector
A DVI graphics source to the DVI connector
2. Connect the stereo audio sources 8 (not illustrated in Figure 7):
The audio of the composite video source 1 to the AUDIO IN AV1
terminal block connector
The audio of s-Video source 1 to the AUDIO IN YC1 terminal block
connector
The audio of the component video source to the AUDIO IN COMP
terminal block connector
The audio of computer graphics source to the AUDIO IN VGA1 terminal
block connector
The audio of the DVI graphics source to the AUDIO IN DVI terminal
block connector
3. Connect the VIDEO OUT 1 and VIDEO OUT 2 HD15F connectors 9 to
the video acceptors, for example, a plasma display and a VGA display.
1 From this section on, all the information is relevant to the CVG-719xl, CVG-720xl and CVG-724xl machines, unless noted
otherwise
2 Switch OFF the power on each device before connecting it to your CVG-724xl. After connecting your CVG-724xl, switch
on its power and then switch on the power on each device
3 You do not have to connect all the inputs
4 Although in the example illustrated in Figure 7 only one source is connected, you may connect both sources simultaneously
5 Sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb, Pr
6 Alternatively, you can connect an RGB signal (not shown in Figure 7), as follows: Red to the Y connector, Green to the
Pb/Cb connector, and Blue to the Pr/Cr connector
7 You can connect up to two graphic sources only on the CVG-724xl, other models in this series have only one VGA graphic
source
8 As required. Not all devices need to be connected
9 In the HDTV mode, the signal goes out via three PINS: PIN 1 is Red or Pr, PIN 2 is Green or Y, PIN 3 is Blue or Pb