CTI Products PCLTA PCI Interface - Manual (Page 20)

PCLTA Installation Manual PCLTA Initialization & Testing
CTI Products, Inc.
68-11199-135
16
5. PCLTA Card Installation
The PCLTA device drivers must be installed prior to installing the card. If the
drivers have not been installed, complete the previous step.
To install a PCLTA card into your PC, follow these steps:
a. Turn off the PC and remove the power cord.
b. Open the PC case and locate an empty slot.
c. Remove the corresponding blank panel from the rear of the PC.
d. Insert the PCLTA card into the slot, ensuring that the edge connectors are
fully mated, and the slot in the rear panel-mounting lug of the PCLTA is
aligned with the threaded hole in the PC chassis.
e. Replace the screw to hold the PCLTA firmly in place.
f. Reinsert the power cord and then restart the PC.
On power-up, Windows will automatically sense the Plug-n-Play adapter, and
associate it with the drivers installed in the previous step. In this case, skip to
Section 6, “PCLTA Initialization and Testing”.
If the Plug ‘n Play features of the card failed, the following “Found New
Hardware Wizard” window may be displayed on startup.