Or 1 (see table 3), Or 2 (see table 3), Or 3 (see table 3) – CTI Products TIB TSAM Interface User Manual
Page 12: E1 a e1 b
TIB Hardware Reference
Option Switches
CTI Products, Inc.
68-10911-100
7
A TIB can monitor 8 receivers (one receiver bank) for FORCE VOTE
information. Option switches 1 through 3 allow the TIB to associate its 8
transmitters with any receiver bank supported by the Comparator I/O Module.
The settings for these switches is shown in Table 3.
Bank
Option Switch Position
1 2 3
Receiver
Numbers
0 *
DOWN DOWN DOWN
1 through 8
1
UP DOWN DOWN
9 through 16
2
DOWN UP DOWN
17 through 24
3
UP UP DOWN
25 through 32
4
DOWN DOWN UP
33 through 40
5
UP DOWN UP
41 through 48
6
DOWN UP UP
49 through 56
7
UP UP UP
57 through 64
Table 3 - Receiver Bank Selectors
* This is the required setting when operating with a CIB.
Figure 4 shows the configuration of the two jumper options available on the rear
of the TIB. These jumpers should be installed at system installation time with
power removed from the TIB.
CA-80024-100
E1 A
E1 B
Figure 4 - Jumper Options