Lightronics AR1202 - Manual (Page 16)

Page 16 of 22
AR – 1202 RTC ARCHITECTURAL DIMMER
Revision 1.93 OWNERS MANUAL 06/03/2008
www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 Tel 757 486 3588
Push
MENU (NEXT) to proceed to the Set Day menu.
SETTING THE DAY OF THE WEEK
The day of the week MUST BE SET when setting or
changing the date. It does not automatically
synchronize to the date setting. Once the day is
correctly set it will continue to track the date.
Use the and buttons to select the day so that it
corresponds correctly to the previously set date. Push
ENTER when the correct day is shown.
A complete layout diagram of the menus for setting
the clock is shown below.
EVENT SYSTEM ENABLE
Events programmed in the AR-1202 will not trigger
unless the event system is set to ON. If the event
system is OFF you can still set the clock and program
event times and dates but they will never be triggered.
Turning events OFF is used to prevent triggers which
may have been forgotten about, incorrectly set, or
otherwise unaccounted for.
T O CONTROL EVENT TRIGGERING
Push ENTER from the Event Setup menu. The display
will show the event system ON/OFF menu.
Use the and button to select ON or OFF. Push
ENTER when the desired ON/OFF state is shown.
PROGRAMMING EVENTS
Events are programmed using the AR-1202 Event
Editor menus. The menu layout is shown below.
MENU (NEXT)
EVENT
EDITOR
EVENT #
001
EVNT 001
S00O ON
E001S000
DATE
E001S000
01/01
E001S000
00:00
E001S000
SMTWTFS
ENTER
ENTER
DATE DAYS
MENU (NEXT)
MENU (NEXT)
MENU (NEXT) MENU (NEXT)
EVENT
SYS OFF
MENU (NEXT)
EVENT
SETUP
ENTER
MENU (NEXT) To Other
Menus
EVENT
SETCLOCK
MENU (NEXT)
EVENT
SYS OFF
SET DAY
MONDAY
EVENT
SETCLOCK
SET DATE
00/00/00
SET TIME
00:00
SET DAY
MONDAY
TIMEZONE
-05HrsGM
DST
NO
ENTER
EVENT
SETUP
ENTER
MENU (NEXT) To Other
Menus
MENU (NEXT)
MENU (NEXT)
MENU (NEXT)
MENU (NEXT)
MENU (NEXT)
EVENT
SYS OFF
MENU (NEXT)
Note: Time Zone
and DST (Daylight
Saving Time) are
not currently used.