Maintenance for performance, 1 about production year, 2 do not fire the nailer when it is empty – MAX SN883RH2 User Manual
Page 18: 3 use a 3-piece airset, 4 use recommended oil, 5 inspect and maintain daily or before operation, Warning, 1) drain air line filter and compressor, 2) keep lubricator filled in air 3-pieces set, 3) clean filter element of air 3-pieces set
18
5. MAINTENANCE FOR PER-
FORMANCE
1 ABOUT PRODUCTION YEAR
This product bears production number at the
lower part of the grip of the main body. The
two digits of the number from left indicates
the production year.
2 DO NOT FIRE THE NAILER WHEN IT IS
EMPTY
3 USE A 3-PIECE AIRSET
Failure to use a 3-piece airset allows the
moisture and dirt inside compressor to pass
into the tool directly. This causes rust and
wear, and results in a poor operating per-
formance. The hose length between airset
and tool should be no longer than 5 m since
a longer length results in a reduction in air
pressure.
4 USE RECOMMENDED OIL
The velocite or turbine oil should be used to
lubricate the tool. Upon completion of opera-
tions, place 2 or 3 drops of oil into the air plug
inlet with the jet oiler. (Recommended Oil :
ISO VG32)
5 INSPECT AND MAINTAIN DAILY OR BE-
FORE OPERATION
Disconnect air supply and empty the maga-
zine when inspecting or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly
6. STORAGE
1 When not in use for an extended period, ap-
ply a thin coat of the lubricant to the steel
parts to avoid rust.
2 Do not store the tool in a cold weather envi-
ronment. Keep the tool in a warm area.
3 When not in use, the tool should be stored in
a warm and dry place. Keep out of reach of
children.
4 All quality tools will eventually require servic-
ing or replacement of parts because of wear
from the normal use.
7. TROUBLE SHOOTING/RE-
PAIRS
The troubleshooting and/or repairs shall be car-
ried out only by the MAX CO., LTD. authorised
distributors or by other specialists.
Supplement to the operating instruction
According to the European Norm EN 792-13 the
regulation is valid from 01.01.2001 that all fas-
tener driving tools with contact actuation must be
marked with the symbol "Do not use on scaffold-
ings, ladders" and they shall not be used for spe-
cific application for example:
∗ when changing one driving location to another
involves the use of scaffoldings, stairs, ladders
or ladder alike constructions e.g. roof laths,
∗ closing boxes or crates,
∗ fitting transportation safety systems e.g. on ve-
hicles and wagons.
(Example)
0 8 8 2 6 0 3 5 D
Year 2008
WARNING
SN883RH2_SN890CH2(34).book 18 ページ ２０１１年７月８日 金曜日 午後６時１分