MaxPower Corp XBDM - Manual (Page 5)

XBDM USER’S MANUAL BYPASS DISTRIBUTION MODULE
Xtreme Power Conversion Corporation (Rev 8/29/13) Page 5
CAUTION
The unit has a dangerous amount of voltage. If either the UPS or BYPASS indicator is on, the unit’s
outlets may have a dangerous amount of voltage even when not plugged into the wall outlet because
the battery from the UPS may continue to supply power.
Care should be taken to undertake installation indoors, free from electrically-conductive particles
which are under temperature and humidity control, in order to reduce the risk of electric shock.
It is best to disconnect the device using the power supply cord. Ensure that the equipment is placed in
a position near the outlet where easily accessible.
All servicing on this equipment must be carried out by qualified service personnel.
The Xtreme Bypass Distribution Module (XBDM) is intended to allow replacement of the UPS
connected without having to shut down the equipment connected to the load circuits on the XBDM.
Caution should be observed as the XBDM is always supplied with power by either the UPS or UTILITY.
Environment
Ensure that all environmental concerns and requirements are met according to specifications listed in
this document, otherwise the safety of installation personnel cannot be guaranteed, and the unit may
malfunction.
Ensure that you remember the following when locating the XBDM:
• Avoid extremes of temperature and humidity.
O
Operating temperature: 0°C to +50°C (+32° to +122° F)
O
Operating elevation: 0 to 3000m (0-10,0000 ft)
O
Relative humidity: 0-90%, non-condensing
O
Storage temperature: 0-65° C (+32 to +149° F)
O
Storage elevation: 0 to 15,000m (0 to +50,0000 ft)
• Provide protection for the equipment from moisture.
• Space and ventilation requirements must be met.