Meriam M130 T_C Thermocouple Calibrator User Manual
Page 11
M130 – T/C Calibrator
Instruction Manual Z1017-IR
E.O. 6566 Sept. 2008
www.meriam.com
Page 11 of 21
SIM (MANUAL) SETUP: Simulation Mode’s Manual menu structure
VALUE
ADJUST
Press ENTER & use increment or decrement group
keys to set a numeric value, press ENTER to start
UNITS
Select desired unit of simulation
C
engineering units are ºC
F
engineering units are ºF
R
engineering units are ºR
K
engineering units are K
TC TYPE
Select T/C type or mV
mV
engineering units are mV
B
engineering units are temperature only
E
engineering units are temperature only
J
engineering units are temperature only
K
engineering units are temperature only
N
engineering units are temperature only
R
engineering units are temperature only
S
engineering units are temperature only
T
engineering units are temperature only
0 – 100
Outputs 0% and 100% of setup
START
Starts 0% of range; ENTER toggles to 100%, 0%...
UNITS
Edit units corresponding to 0 – 100, same as above
TC TYPE
Select T/C type, same as above
URV
Upper Range Value for T/C and unit selected
press enter & use +/ – keys
LRV
Lower Range Value for T/C and unit selected
press enter & use +/ – keys
STEP 25%
Outputs 0, 25, 50, 75 and 100% of setup below
START
Starts 0%, ENTER increases 25% to 100% & back
UNITS
Edit unit for STEP 25%, same as above
TC
Select T/C type, same as above
URV
Upper Range Value for T/C and unit selected
press enter & use +/ – keys
LRV
Lower Range Value for T/C and unit selected
press enter & use +/ – keys
Notes: 1. Main and submenus are continuous, scrolling menus. Use W or X
to scroll through the menus.
2. Use SETUP key to discontinue simulation activity.