Meriam M130 T_C Thermocouple Calibrator - Manual (Page 12)

M130 – T/C Calibrator Instruction Manual Z1017-IR
E.O. 6566 Sept. 2008
www.meriam.com
Page 12 of 21
SIM (AUTO) SETUP: Simulation Mode’s Manual menu structure
AUTO Press SETUP to enter
A.STEP 1 Title of Auto Step 1 simulation; setup saved here
for subsequent re-use
START Starts A.STEP 1
UNITS Select desired unit of simulation
C engineering units are ºC
F engineering units are ºF
R engineering units are ºR
K engineering units are K
TC TYPE Select T/C type or mV
mV engineering units are mV only
B engineering units are temperature only
E engineering units are temperature only
J engineering units are temperature only
K engineering units are temperature only
N engineering units are temperature only
R engineering units are temperature only
S engineering units are temperature only
T engineering units are temperature only
URV Upper Range Value for T/C and unit selected,
press enter & use +/ – keys
LRV Lower Range Value for T/C and unit selected,
press enter & use +/ – keys
STEPS Input number of steps desired for test
UP press enter & use + / – keys
DOWN press enter & use + / – keys
DWELL Select desired dwell time for test points
Manual Manually advance simulation
5 SEC. Auto advance simulation every 5 seconds
10 SEC. Auto advance simulation every 10 seconds
A.STEP 2
same as A.STEP 1 above
A.STEP 3
same as A.STEP 1 above
A.RAMP 1 Title of Auto Ramp 1 simulation; setup saved here
for subsequent re-use
START Starts A.RAMP 1
UNITS Select desired unit of simulation
C engineering units are ºC
F engineering units are ºF
R engineering units are ºR