0 requirements, 1 hardware requirements, 1 minimum hardware requirements – Micromod Micro-DCI: 53SU6000 COMMUNICATIONS SERVICES User Manual
Page 11: 2 hardware compatibility, 0 - requirements
53SU6000 INSTALLATION AND SETUP GUIDE
Introduction 3
2.0 REQUIREMENTS
2.1 Hardware Requirements
2.1.1 Minimum Hardware Requirements
The following minimum hardware requirements must be met to successfully load and run the 53SU6000
software. These include:
•
An Intel-based, Windows 2000 Professional/XP Professional -compatible personal computer
(PC) with a Pentium processor and minimum speed of 200 MHz.
•
128 MB of memory.
•
A 4 MB disk drive.
•
A CD-ROM drive. (The 53SU6000 software is distributed on CD-ROM.)
•
An IBM AT-compatible 101 key keyboard.
•
A cursor positioning device. This can be a two or three button mouse, trackball or other
Professional-compatible cursor positioning device.
•
A video board and monitor which support at least 256 colors (8 bit mode) at a minimum of 640
x 480 pixel resolution.
•
A 3.5 inch floppy disk drive for small capacity removable storage.
•
A parallel port for printing and hardware key installation.
•
A full size ISA bus slot is required for each installed Supervisor card.
2.1.2 Hardware Compatibility
The 53SU6000 software can be installed and run on any personal computer which meets the minimum
requirements listed in
and which can run the Windows 2000 Professional/XP Professional
operating system.
When the 53SU6000 software and supported third party software (e.g., Microsoft EXCEL) are installed on
qualified hardware, full support for performance and reliability is provided. WHEN THE 53SU6000 SOFT-
WARE IS INSTALLED ON ANY EQUIPMENT OTHER THAN THE QUALIFIED AND SUPPORTED MOD-
ELS LISTED ABOVE, AND/OR IS USED IN CONJUNCTION WITH SOFTWARE OTHER THAN THAT
SUPPORTED FOR USE WITH THE 53SU6000, ONLY LIMITED SUPPORT WILL BE PROVIDED. In
such cases, limitations on the extent of support are at the discretion of the company.