Micromod Micro-DCI: 53SU6000 COMMUNICATIONS SERVICES - Manual (Page 12)

53SU6000 INSTALLATION AND SETUP GUIDE
4 Introduction
2.2 Software Requirements
The software versions required for the 53SU6000 are discussed in this sub-section, as well as require-
ments for compatibility between the 53SU6000 and other Micro-DCI products.
2.2.1 Requirements
The following software versions are required for the 53SU6000, Release 3.0:
• Windows 2000 Professional, SP2 or Windows XP Professional
• 53SU6000 Application Software, Version 3.0
• Supervisor Card Firmware, Rev. 5
2.3 Micro-DCI Instrument Compatibility
In order to use the new Release 3.0 of the 53SU6000 Micro-DCI Communication Services system soft-
ware, the following changes or upgrades must be made to any Micro-DCI instruments to be used with the
new software:
• Supervisor cards REQUIRE an upgrade to REV5 of the firmware
• 53MC5000 units with firmware levels of REV0 through REV4 generate pre-acknowledged
alarms. REV5 firmware is available that enables alarms to be acknowledged by the operator.
• 53SL6000 units with REV0 firmware generate pre-acknowledged alarms. REV1 firmware is
available that enables alarms to be acknowledged by the operator.
• The following control modules can only be used in Hierarchical Displays by connecting them to
CON modules on the Supervisor Card:
53MC1000
53MC
53MC4000
50KM