Minuteman E Ride 26 - Manual (Page 26)

26
First Operation
the recovery tank. (Refer to “Mainte-
nance” section for instructions.)
8. Refill the solution tank and continue
scrubbing until the job is done or the
machine runs out of charge.
The battery/ fault gauge (Fig.
5/3) will flash to signal that the
machine is almost out of pow-
er. When this signal is dis-
played, all functions will shut
off (brushes will turn off, the
scrub deck and squeegee will
raise. The key switch must be
turned OFF then ON to reset
the machine. The machine will
then only have a few minutes
left of reserve power for a short
vacuum only mode to pick up
remaining solution on the floor
and transport power to drive to
the battery recharging station.
If the machine is operated for
an excessive period of time af-
ter cleaning functions have
stopped, it will eventually turn
itself off. The machine will have
to be pushed back to the re-
charging station.
4.6 Stop Machine
To stop scrubbing, select the transport
mode (Fig. 5/13). This will automatically
stop the solution flow, raise the scrub-
deck, raise the squeegee, and turn off
the vacuum motor (15-second delay).
4.7 After Work
Refer to the “Maintenance” section for
specific maintenance instructions de-
scribed below.
1. When finished scrubbing, select the
transport mode (Fig. 5/13), all clean-
ing functions will shut off. Move the
machine to a suitable site for mainte-
nance.
2. Empty and clean the solution tank
3. Empty and clean the recovery tank
Observe the legal directives
and local regulations for dis-
posal of detergents.
4. Remove and clean the brushes or
pad holders.
5. Remove and clean the rear squee-
gee
6. Check operating fluid levels, function
and setting.
7. Remove and clean the side squee-
gees.
8. Clean the machine.
Do not clean the electrical
parts by means of high-pres-
sure cleaning equipment.
9. Check the maintenance schedule
and perform any required mainte-
nance before storing the machine.
10.Charge batteries.
11.Store the machine indoors in a clean
dry place.
Keep from freezing
Leave the solution and recov-
ery tank lids open for ventila-
tion to prevent odor build-up.
12.Turn key switch OFF and remove
key.
Remove the key to avoid unau-
thorized use of the machine.