Minuteman E Ride 26 - Manual (Page 45)

45
Maintenance and Care
7.7.5 Adjust side squeegee
The side squeegees channel the dirty
solution to the rear squeegee. The side
squeegees may require adjustments
when replacing worn blades or to
achieve optimum performance.
1. Loosen the two (front and back)
wingnuts located behind the side-
squeegee.
2. Lower the scrub deck by switching to
a scrubbing mode and when the
brushes start up, turn OFF the key
switch.
3. At this point the side squeegee
should be resting vertically (no de-
flection) on the floor. Press down on
the side squeegee bracket assembly
from each end while making sure
that the blade is uniformly deflected
in a 45 degree angle along its whole
length.
4. Tighten the wingnuts.
5. Turn the steering wheel all the way to
the left or right and start pushing the
machine to the side to inspect the
blade deflection and wiping action.
6. Repeat the steps above until a satis-
factory result is obtained.