Minuteman E Ride 26 - Manual (Page 46)

46
Maintenance and Care
7.8 Cylindrical Brush Deck
1 Brush deck
2 Roller bumper
3 Dirt hopper
4 Side squeegee pivot bracket
5 Brush hub
6 Drive hub
7 Notched end of cylindrical brush
Fig.16
7.8.1 Clean dirt hopper
Clean dirt hopper (Fig. 16/3) at daily in-
tervals or as required.
Remove dirt hopper by lifting and slid-
ing sideways. Clean the hopper and re-
place. 7.8.2 Remove brushes
1. Remove the yellow star shaped knob
and swing the side squeegee brack-
et (Fig. 16/4) along the hinge.
2. Release brush hub (Fig. 16/5) by re-
moving the three thumbnuts.
3. Remove and check the brushes.
7.8.3 Clean brushes
Clean brushes in the brush deck at daily
intervals or as required.
7.8.4 Replace brushes
Check brushes in the brush deck for
wear at daily intervals and replace as
required.
1. Insert brush into brush deck and ro-
tate until it catches on the drive hub
(notched end must face inward) (Fig.
16/6&7).
2. Place the brush hub and secure it
with the three thumbnuts and lock
washers.
3. Swing the side squeegee back into
place and tighten the yellow star
shaped knob.
7.8.5 Change roller bumper
Check roller bumpers (Fig. 16/2) at
weekly intervals and replace if required.
1
2
3
4
5
6
7