MotorVac TRANSTECH HD - Manual (Page 3)

G
System Features and Functions
The front of the INDUSTRIAL TRANSTECH cabinet contains the control panel, the fluid fill neck for adding new
transmission fluid, and the fluid level windows. (See page 1-4 for complete theory of operation)
Front View - Control Panel Features and Functions
A. Change Fluid button • Starts exchanging used fluid for new fluid / Service in progress mode.
• Starts the unit during the “Prime” procedure.
B. Drain button • Drains fluid from vehicle’s transmission when performing the drain pan procedure.
• Provides momentary drain function when the units “Complete” light is illuminated.
C. Low Vehicle Fluid
warning light
Illuminates when:
• Vehicle transmission fluid is two quarts low.
• When vehicles transmission is empty at end of drain pan procedure.
D. Complete light Illuminates when:
• The service procedure has been completed
• The stop button has been pressed & unit’s alarm is not sounding
E. Engine – Start /On
warning light
• Flashes when the vehicle’s engine needs to be started.
• Illuminated constantly when vehicle’s engine is running & the unit senses fluid pressure.
F. Engine - Stop/Off
warning light
• Flashes when the vehicle’s engine needs to be stopped.
• Illuminated constantly when the vehicle’s engine is OFF.
G. Fill button • Adds a pre-programmed amount of fluid to the transmission at beginning of service.
• Adds a pre-programmed amount of fluid to the transmission after the Drain procedure.
• Provides momentary fill function when the unit’s Complete light is illuminated.
H. Low Clean Fluid
warning light
Illuminates when the clean fluid tank in the machine is empty / “zero” level.
I. Fill- Additional fluid
count lights Will illuminate according to the amount of pre-programmed fluid that will be added.
J. Stop button • Stops units pump & completely resets unit (if alarm is not sounding).
• Stops units alarm if alarm is sounding.
K. Empty Waste button Empties used transmission fluid from the unit’s waste tank.
B
D
E
F
H
C
I
J
K
A