MotorVac TRANSTECH HD - Manual (Page 8)

ENGINE START/ON:
• The light will flash if the engine needs to be started to continue
• The light will be on constantly when the engine is running or if the machine’s system is pressurized over 4
psi.
ENGINE STOP/OFF:
• The light will flash if the engine needs to be stopped/turned off.
• The light will be on constantly when the engine is not running.
EMPTY WASTE:
• The light will be on when the waste fluid is at/or over 4 quarts in the WASTE tank. The unit will not run
unless the level in the waste tank is less than ¼ full (approximately 4 qts.).
STOP:
• Will turn off an alarm without stopping the service when sounding.
• Will stop the pump and revert the system to recirculating mode, (if no alarm is sounding).
NOTE: If the unit needs to be stopped completely while an alarm is sounding, press the STOP button TWICE.
The first press will stop the alarm and the second press will stop the pump.