Multichannel Systems STG3008-FA Manual - Manual (Page 15)

First Use of the Stimulus Generator
9
3.3 Driver Installation
The stimulus generator is a plug and play device. The driver is automatically installed together
with the MC_Stimulus II program.
The Windows operating system detects a new hardware when the stimulus generator is connected
to the computer, if the program has not been installed beforehand. Simply cancel the driver
installation and proceed with the installation of the MC_Stimulus II program.
Important: Please make sure that you have full control over your computer as an administrator .
Otherwise, it is possible that the installed hardware does not work properly.
If there are any problems, and you need to install or update the driver manually, please see
the MC_Stimulus II Help for more information.
3.4 Installing the Software
System requirements
Software: One of the following Microsoft Windows ® operating systems is required:
Windows 7, Vista or Windows XP (English and German versions supported).
Hardware: USB port (2.0 High Speed)
Installing the software
Please check the system requirements before you install the software. MCS cannot guarantee
that the software works properly if these requirements are not fulfilled.
Important: Please make sure that you have full control over your computer as an administrator .
Otherwise, is possible that the installed software does not work properly.
1. Double-click Setup.exe on the installation volume. The installation assistant will show up
and guide you through the installation procedure.
2. Follow the instructions of the installation assistant.
Select radio button "STG3008-FA". When you have finished the installation of the MC_Stimulus II
software and the STG driver, you can now operate the STG3008-FA.