Multichannel Systems TC01-TC02 Manual - Manual (Page 13)

Installation and Operation
9
3.3 Operating the TC01/02
3.3.1 Starting the TC01/02
All functions are set in the menu of the TC01/02, including switching the TC01/02 on and off.
If the TC01/02 is switched off, it goes into standby mode. The instrument and display are only
switched off completely when the TC01/02 is disconnected from the power supply. Most of the
power consumption of 6 W in standby mode is used by the power supply unit.
In the main menu on the display, select On / Off. The TC01/02 starts to control the temperature
on the selected channels immediately. If the TC01/02 is connected properly, the actual
temperature and the setpoint temperature are displayed in the Temperature Control view.
3.3.2 General User Interface
The front screen display shows the actual temperature and the setpoint temperature. You can
enter the next menu levels by pressing the Select button. Go to a menu command with the Up
and Down buttons and press Select to select the command highlighted by an arrow and to enter
the next menu level. The functionality of the button array on the front panel is described in the
following.
Up Goes to the menu command above or increases
the displayed parameter value. Tip once to increase the
value in a small single step, press longer for larger steps.
Down Goes to the menu command below or decreases
the displayed parameter value. Tip once to increase the
value in a small single step, press longer for larger steps.
Select Press this button to switch from Temperature Control
view to the Main menu. Selects the command high
lighted by an arrow in the menus and enters the next
menu level.
Back Leaves the menu level and goes back to the next higher
menu level. Settings that were selected or modified are
applied and saved automatically when leaving a menu.