Dixon Valve 50 TON RAM SEC02 External Swaged Holedall - Manual (Page 6)

50 Ton Ram Instruction Manual
1¼" through 4" Standard & Long Holedall Swaged Couplings
customer service 800 • 355 • 1991
4 Section 2
Move the directional control lever to the “REVERSE”
position and depress the button on the remote.
Retract the cylinder far enough (approximately 1") to
allow a tie down bar be placed so that the die does
not come out of the die holder. Secure the tie down
bar by tightening the bolt. Continue retracting the
cylinder until there is sufficient room for the stem
and ferrule to clear the die bed.
Position a rubber sheet or pad under the die bed.
While holding the die in place with one hand, loosen
the bolt on the tie down bar and move the tie down
bar so that it clears the die.
Slowly slide the hose
towards the pusher. When the die clears the die
holder, one or both halves may fall to the floor. If
one half remains on the ferrule, tap it with a mallet
until it releases. If both halves remain on the ferrule,
it may require the halves be pried apart at the seam.
Wipe excess lubricant from hose and ferrule. Bring
hose with stem and ferrule back through die bed.
12b
12a
11