American Dynamics ADCC1100 - Manual (Page 40)

34
ADCC1100
Programming a Smart Card
A smart card with sufficient privileges must be first used in order to access the key-
board's program mode.
1. Press the PROGRAM MODE tab key. Press the NEXT soft key.
2. Press the SMART CARD soft key. Press the PROG SC soft key.
3. The keyboard will display the message "Please Replace Smart Card". Insert the
smart card to be programmed and wait until the process is completed.
Programming a New Smart Card
A smart card with sufficient privileges must be first used in order to access the key-
board's program mode.
1. Press the PROGRAM MODE tab key. Press the NEXT soft key.
2. Press the SMART CARD soft key.
3. Press the USER NAME soft key. This will enter the text editor where the user
name can be entered. When the user name has been entered, the display will
return to the program smart card menu.
4. Press the USER ID soft key. Enter a user ID number. If the number "0" is used,
the user will be prompted to use the User ID stored on the switching matrix during
log on.
5. Press the MACRO NAME soft key. Enter a macro name using the text editor. This
name is used to identify a set of macros programmed to the smart card and
enables quick identification of a macro set programmed to the card.
6. To set the user level for the new smart card, press the ADMIN soft key. At each
key press, the soft key icon will change to show either ADMIN, OPER'T, or
SUP'VSR.
7. If camera, monitor, or control partitioning is to be programmed, this can be done
now (if it has not already) —see Configuring Partitions.
8. Press the PROG SC soft key. The keyboard will display the message "Please
Replace Smart Card". Insert a blank smart card and wait until the process is
completed.