American Dynamics ADCC1100 - Manual (Page 49)

43
Keyboard Installation and Operation
Appendix A: Monitor Arming Commands
Monitors are armed for alarm call up with codes that specify the following three parameters:
1. The display method (single, dual, or block monitors).
2. The queuing method (sequence or hold).
3. The clearance method (instant, auto, or manual).
To arm a monitor with an ADCC1100 keyboard:
1. Call the monitor to be armed.
2. Press the PROGRAM MODE tab key.
3. Enter the monitor arming code number (see table).
4. Press the F2 soft key.
A keyboard operator can also program any monitor armed for instant or auto clearance, for clearance via manual
override. Manual override is enabled or disabled after the arming code is programmed. If enabled, an "A" will appear
after the three-letter acronym for the arming code that appears on the monitor status line.
When using the AD1024 matrix switcher/controller system, monitors can be armed through system setup software
with a PC interface, or through the AD1024 embedded software with an ADCC1100 keyboard. Following is a table of
monitor arming codes and the commands that enable the codes.
* In dual display applications, the first three-letter acronym is displayed on the hold monitor. The second three-letter
acronym is displayed on the sequence monitor.
Monitor Arming Code Monitor Acronym Command Sequence
Display Arming Status see entries below 300, F2
Single, Sequence, Instant SSI 301, F2
Single, Sequence, Auto SSA 302, F2
Single, Sequence, Manual SSM 303, F2
Single, Hold, Instant SHI 304, F2
Single, Hold, Auto SHA 305, F2
Single, Hold, Manual SHM 306, F2
Block, Sequence, Instant BSI 307, F2
Block, Sequence, Auto BSA 308, F2
Block, Sequence, Manual BSM 309, F2
Block, Hold, Instant BHI 310, F2
Block, Hold, Auto BHA 311, F2
Block, Hold, Manual BHM 312, F2
Dual, Hold, Instant DHI/DSI* 313, F2
Dual, Sequence, Instant
Dual, Hold, Auto
DHA/DSA* 314, F2
Dual, Sequence, Auto
Dual, Hold, Manual
DHM/DSM* 315, F2
Dual, Sequence, Manual
Disarm Monitor
316, F2
Enable Monitor Override 317, F2
Disable Monitor Override 318, F2