AudioBahn MULTIFUNCTIONAL SOURCE UNIT A3351 - Manual (Page 12)

Power Off
Press [OFF] button and hold for 1~2 seconds to turn off the unit.
Selecting Source
Press [SOURCE] to change the source.
[A-BASS]
[Rotary Encoder]
[ S O U R C E ]
Use the following instructions (Fig.1.2)to detach the faceplate. Press the RESET button
(Fig. 1.3) with a ballpoint pen or a paper clip in the hole at the lower left corner of the unit
and gently press it in until the button clicks.“Audiobahn Car Audio System” appears on the
display and then “Security Code:” with a blinking cursor. Input the Security Code on
Product ID card by turning the Rotary Encoder to choose the number of the digit at the
cursor position. Press the [>>l] button to advance the cursor. Repeat the above
procedure. Once all digits are entered, press[Enter].
Power On
1) Turn your car’s ignition key to the ACC or ON position.2) Press any button on the
faceplate (except [OPEN] or [EJECT]) to turn on the unit. 3) “Audiobahn Car Audio
System” appears on the display for a moment. If you were listening to a song on a CD,
the unit plays the song you were listening to the last time.
Note: Last Song / Level Memory The very first time the power is turned on,
the volume will be set to 35.When the unit is turned on, the unit goes to the
previous setting you were listening to before the unit was turned off. All the
presets, settings and the mode are memorized when the unit is turned off.
Basic Operation
10