LumaStream Trinity PERMANENT - Manual (Page 11)

Document: 66APPMAN Rev: H 22 of 32
11.0 0-10 Vdc ANALOG INTERFACE
11.1 LED Status Indicator

Power Indicator-Green LED will turn off if no power is detected.

Dimming-Green LED will flash when output master is at full on (100%
light intensity). Green LED will vary in intensity proportionally to mas-
ter 0-10 Vdc control signal for intensity levels less than 100%.
Zone #4
Output Channels
10,11,12
Zone #1
Output
Channels 1,2,3
Zone # 3
Output
Channels 7,8,9 Zone #2
Output
Channels 4,5,6
Master & Zone
Dimming Inter-
face Connections
P
ow
e
r I
nd
ic
a
to
r
Ana
log D
im
m
ing
Acti
ve
Document: 66APPMAN Rev: H 11 of 32
7.0 INPUT REQUIREMENTS
7.1 Electrical Input Specifications:
Input specifications are defined in table 1 at the beginning of this
manual
7.2 Input Connections:

Remove junction box cover and connect the AC line wires (ground, line
neutral) to the terminal block as shown.

When installing the TRINITY LED Driver Dimmer, connect to the
appropriate sized building breaker or disconnect device for line and
neutral connections in accordance with local, province, state, or country
regulations.
CAUTION
RISK OF DAMAGE:
DO NOT connect AC input of power unit to a phase cut dimmer or
dimming panel. It will cause internal damage to the power unit