Ransburg 9040 Cascade LV Control Unit 76580 - Manual (Page 11)

CP-97-04.3 8 8 8 8 8
9040 Cascade Low Voltage Control Unit - Introduction
> Except where indicated, this manual is
applicable to all models of the 9040 Cas-
cade control unit.
N O T E N O T E N O T E N O T E N O T E
required to operate the spray applicator in one
convenient location. See “Parts Identification”
section of this manual for information on ordering
Totalizer or Pneumatics modules.
The 9040 Cascade control unit has also been
modularly designed so that two half rack 9040
chassis will fit into one full rack enclosure, in
multiple applicator installations. The full rack
enclosure has been designed for mounting in
standard 19-inch rack mount cabinets.
The 78398-0X, 9040 Control Unit for single bell
applications, includes an additional normally open
pressure switch (3PS) connected between fuse
1FU and ON/OFF switch 1SW. The air input to
this pressure switch is located at the rear of the
control unit and is labeled 3PS. When the air
B - Designates domestic (1) or export (2) version
C - Designates no (0), intrinsically safe (1), or fiber optic (2) Totalizer module
D - Designates no (0), applicator (1), or automatic applicator (2) Pneumatics module
E - Designates the number of Pneumatics and/or Totalizer modules desired
signal is removed from this input, the contacts of
the pressure switch are open and AC power to
the control unit is disconnected. The high voltage
output from the 78837 Aerobell Control Module
removes the air signal from pressure switch 3PS
whenever the dump or solvent outputs are active.
In this manner it is ensured that the control unit is
powered OFF whenever the system is in dump
or solvent mode.
The 9040 Cascade Control Unit is available for
hand and automatic REA/REM Cascade spray
applicators as follows:
76580-AXXXX
76580-BXXXX
76580-1BCDE
76580-2BCDE
76580-4BCDE
76580-5BCDE
76580-6BCDE
76580-7BCDE
76580-8BCDE
76580-9BCDE
78398-0X
9040 9040 9040 9040 9040
Part # Part # Part # Part # Part # Applicator # Applicator # Applicator # Applicator # Applicator # Used with Applicator T Used with Applicator T Used with Applicator T Used with Applicator T Used with Applicator Type ype ype ype ype
M90 Applicator
REA900A Automatic
REA-70 Applicator
REM Applicator
REM Automatic
REA9000 Robot or Automatic
REA-90 Waterborne Applicator
REA-90 Solventborne Applicator
REA-90 Solventborne Automatic
REA-90 Waterborne Automatic
Aerobell 33
RPM Aerobell 77073
77359
72074
72364
73499
76110, 75795
75786
75785
75787X-XXXX1
75787X-XXXX2
AER5001-XX4X1
RPM-5XXXX-PSX
ARCHIVE