Ransburg REA III Auto Applicator 70393 User Manual

Page 31

Advertising

AA-82-01.3

2 8

REA III 100kV Automatic Applicator - Maintenance

Barrel to Body Assembly

1. Remove piston housing [61] from body [26].

DO NOT

NOT

NOT lose parts stored in piston

housing.

C A U T I O N

!!!!!

2. Place gasket [13] into the front body [26]
chamber.

Secure the new gasket in place by

splitting it at the top and pressing it into the
chamber. The top is the broadest of the two
large hole margins.

N O T E

3. Place new o-ring [38] on resistor housing [37].

4. Insert resistor housing [37] into the upper body
chamber and slide the barrel assembly straight
into the front body chamber over housing [37].

Be SURE

SURE

SURE that conductive sponge [36]

is in place. If it is not, the applicator will
eventually malfunction.

C A U T I O N

!!!!!

The needle shaft [7] should engage

valve rod extension [23].

N O T E

5. Secure the barrel assembly with nut [11] and
tighten.

Nut [11] should be secured hand tight

only. NEVER

NEVER

NEVER apply more than 10 lbs•ft

(13.5 Nm) torque.

C A U T I O N

!!!!!

6. With the needle valve and piston shaft [52] fully
forward, secure lock nuts [57] and [58] onto
extension [23]. Allow 1/16-inch gap between nut
[57] and shaft [52].

Projection on nut [58] MUST

MUST

MUST face the

rear of the applicator.

N O T E

The fluid valve shaft travel MUST

MUST

MUST be

adjusted so that the air valve is always
triggered FIRST

FIRST

FIRST. If the air does not turn on

BEFORE

BEFORE the fluid, readjust nuts [57] and
[58] in relation to shaft [52].

C A U T I O N

!!!!!

7. Engage fluid tube [69] to barrel [8] with fittings
[9] and [10].

Advertising

Popular Brands

Popular manuals