RECON 264146 RAM Cab Light (Dodge) - Manual (Page 10)

10 | P a g e
-Now Place The Cab Light On The Mark You Made From The Windshield, Line Up The Screw Holes So You
Can See The Line Through The Hole.
-If Your Marker Can Fit Through The Screw Holes on The Recon Light.. by All Means Use It. Otherwise
Find a Scratch All or Something That Will Fit Through The Hole. With The Lights In line, Scratch Inside
The Hole Onto The Roof.
-Now Remove The Light and Measure 2 Inches From The Front Scratched Mark (In between The Two
Scratches) and Mark It. That Will Be Your Wire Hole
-Repeat This Step For All 5 Cab Lights - You Are Now Set To Drill -
Drilling Marked Holes
-Using A 1/8" Drill Bit, Drill The Front and Rear Screw Hole (Be Careful of Anything on The Interior Part)
-Now Using The Larger Drill Bit Drill The Hole For Your Wires.
-Repeat x5 - You Can Now Remove The Marker From Your Roof (Clean Any Metal Shavings off Your Roof
First) and Avoid Any "A Holes"