RECON 264146 RAM Cab Light (Dodge) - Manual (Page 6)

6 | P a g e
Roof Layout and Drilling
With Proper Measurement, And A Confident Installer, Drilling The 15 Holes Should Not Be An Issue
-This Part may become Tricky, A Good Understanding Before Measuring Will Be Needed.
- The Marking Device I Used Was A Black WET Erase Marker (Will Clean Up Nice With Water When
Done)
Setting Up Measuring Device
-Layout One Tape Measure Across The Roof of The Cab From Door To Door & Close Doors Onto Tape
Measure (This Will Hold It In Place)
-As You Can See With The Doors CLOSED The Tape Measure Starts At 3" - That Is Now 0" (Every
Measurement Will Be Minus 3") and Ends At 56"
-Now, To Get The Tape Even Front To Back - Measure 6" Up From The Windshield on Both Sides and
Mark With The Wet Erase Marker. We Can Now Measure Precisely At 6" Above The Win shield.
-With Another Tape Measure, Run It Across Door To Door (Like The Other One), Only Place This One
Right Where The Windshield Meets The Roof. Now Close The Door - This Tape Should Also Start At 3" To
Prevent Confusion.