RECON 264146 RAM Cab Light (Dodge) - Manual (Page 9)

9 | P a g e
Now The 2nd and The 4th Cab Light Can Be Measured 3 Ways:
• 12.5" From The 1st and 5th Cab Light Mark (Top Tape and Bottom Tape)
• 18" From Door To Door (19" on the Bottom Tape)
• or 8.5" From The Center Cab Light Mark
-The Simple Layout Is As Follows:
Marking Drilling Holes:
-The Best Length (I Found Anyway) From the Windshield To The FRONT of The Cab Light Was 4" For
The Center (3) Cab Lights and 6" For The Outside (2) Cab Lights. This Will Allow The Curve of The Light
To Fit The Cab (To Prevent Leaks and Bowing of The Roof)
-Now You Should Have Two Sets of Marks High and Low For The Placement of The Cab Lights - Remove
The Tape Measures and Connect The Marks Using A Straight Edge or Ruler W/ The Wet Erase Marker, At
Least 12" Up the Roof Perpendicular To the Tape Measure. (I Did Not Have A Tape Measure and Used A
Piece of Sheet Metal)
-On the Line You Just Made, From The Windshield Mark Up 4" For The Center 3 Lines and 6" For The
Outside 2 Lines (This Will be The Front Most Point of The Cab Light, Not The Screw Hole!)