SKC Limited Universal MTX Pump Operating Instructions - Manual (Page 13)

www.skcltd.com 224-UMTXM Issue F Page 11
APPLICABLE TO ALL MODELS
1) Charging the Battery Pack
Prior to first use the battery pack should be fully charged, ideally overnight.
The Universal MTX series pumps must only be charged using the correct SKC chargers (Part Nos. 223-203A
- single charger, 223-103A - five station charger).
The charger is supplied with mains input plugs suitable for use in the UK, Europe, USA and Australia / New
Zealand. Select the correct mains input plug and fit it to the charger.
Plug the charger output jack plug into the mating socket at the rear of the battery pack. Plug the charger into
the electrical mains supply and switch on the power. The LED indicator on the charger will illuminate to indicate
that the charger is charging at full rate.
After 16 hours the charger will automatically switch to trickle charge, identified by the LED indicator on the
charger flashing on and off.
When fully charged disconnect the charger jack plug from the battery pack.
2) Accessing the Controls
To access the controls unfasten the screw retaining the anti-tamper control cover (No. 9) using the large bladed
screwdriver attachment of the supplied toolkit, and remove the cover to access the controls.
3) On/Off Switch (No. 10)
Set the on/off switch to the ON position and the pump will start to run. On Models 224-PCMTX4 & 224-PCMTX8,
the LCD screen will activate, and show the legends BATT, SAMPLE RUNNING and four zeros. If left running
the timer display will increment in one minute steps up to a maximum of 9999 minutes (approximately one
week), at which point the timer display will revert to 0000 minutes and continue to increment.
Getting Started